Ecmweb 2502 703ecmscfig1
Ecmweb 2502 703ecmscfig1
Ecmweb 2502 703ecmscfig1
Ecmweb 2502 703ecmscfig1
Ecmweb 2502 703ecmscfig1

Short Circuits

March 1, 2007
The plant I recently relocated to uses a complicated HVAC system to deal with chemical fumes and humidity as well as heating and cooling. My new supervisor, not well versed in the electrical field, was quite concerned about a noise he heard coming from an electrical box. When he directed me to the device, I quickly diagnosed the trouble. It was a rusty armature in a Size 2 combination

The Flame Thrower

The plant I recently relocated to uses a complicated HVAC system to deal with chemical fumes and humidity as well as heating and cooling. My new supervisor, not well versed in the electrical field, was quite concerned about a noise he heard coming from an “electrical box.” When he directed me to the device, I quickly diagnosed the trouble. It was a rusty armature in a Size 2 combination motor starter and disconnect. I saw this as an easy opportunity to show my skills in correcting electrical problems quickly. After removing the armature, I carefully resurfaced and cleaned it in the shop. Back at the enclosure, I sprayed the lower, hard-to-reach areas of the contactor to remove some rust and then reassembled the unit. I was pleased the process had only taken 10 minutes. Knowing the contactor would pick up just after racking in, I was expecting to hear only a slight hum from the enclosure. However, as I closed the disconnect flames billowed out between the bottom of the cabinet and door. I quickly racked it out and opened the door to find that the manufacturer's literature, which was being stored in the bottom of the cabinet, was in flames. I quickly pulled out the paper and soon found several wires had damaged insulation. Unfortunately, I now had to rewire the starter. My advice to you is never use contact cleaner on a live circuit. If you do, make sure it isn't flammable.
Mike Owens
Indianapolis



Plumber's Water Show

In a chemical plant where I worked, the soda products unit was undergoing major production improvements, including bringing in more water and electricity. The plumbers made the final connection to the 3-inch galvanized water pipe they had stubbed in earlier, and turned on the water. Suddenly, everything in the plant went silent. Water was spraying out of every starter fed from the wiring gutter the 3-inch conduit was connected to.
Walter E. Wallis, P.E.
Middletown, N.J.


Got a story about a jobsite blunder? Send it to [email protected]. If we publish it, we'll send you a check for $25.

Voice your opinion!

To join the conversation, and become an exclusive member of EC&M, create an account today!

Sponsored Recommendations

Electrical Conduit Comparison Chart

CHAMPION FIBERGLASS electrical conduit is a lightweight, durable option that provides lasting savings when compared to other materials. Compare electrical conduit types including...

Fiberglass Electrical Conduit Chemical Resistance Chart

This information is provided solely as a guide since it is impossible to anticipate all individual site conditions. For specific applications which are not covered in this guide...

Considerations for Direct Burial Conduit

Installation type plays a key role in the type of conduit selected for electrical systems in industrial construction projects. Above ground, below ground, direct buried, encased...

How to Calculate Labor Costs

Most important to accurately estimating labor costs is knowing the approximate hours required for project completion. Learn how to calculate electrical labor cost.