Ecmweb 5905 12 05 13 Wwhcode Watch 1promo
Ecmweb 5905 12 05 13 Wwhcode Watch 1promo
Ecmweb 5905 12 05 13 Wwhcode Watch 1promo
Ecmweb 5905 12 05 13 Wwhcode Watch 1promo
Ecmweb 5905 12 05 13 Wwhcode Watch 1promo

What’s Wrong Here? Hint: Dangerous Curves Ahead

Dec. 5, 2013
Can you identify the Code violation(s) in this photo?

How well do you know the Code? Think you can spot violations the original installer either ignored or couldn't identify? Here's your chance to moonlight as an electrical inspector and second-guess someone else's work from the safety of your living room or office. It's your turn to identify the violation.

Hint: Dangerous curves ahead

Find the Answer

Section 225.10 of the 2011 NEC permits UF cable as a wiring method on the outside of buildings. In addition, 340.10(3) permits UF to be used in an outdoor wet location. However, 340.12 does not permit UF to be installed where exposed to the sun, unless it is sunlight-resistant type UF. If the cable is not sunlight resistant, it will become brittle and damaged by the prolonged effects of sunlight.

Some of the bends that are made in this cable are extremely sharp and constitute a violation of 340.24, which requires bends be made in the cable so as not to damage the cable or conductors. The inner curve of the bend radius must be at least five times the diameter of the cable. Therefore, the top-most bend appears to be fine, but the two lower bends are simply too sharp. This could cause damage to the insulation of the conductors and to the cable jacket. This damage may eventually lead to arcing and possibly even a fire.

The type of insulated staples used to secure the cable can also be questioned. They are most likely not suitable for this wet location or approved for use in areas exposed to sunlight. Section 300.6(A) requires ferrous metal to have suitable protection against corrosion, and 300.6(C)(1) requires nonmetallic equipment to be sunlight resistant where exposed to the sun.

About the Author

Russ LeBlanc | Owner

Russ started in the electrical trade as an apprentice in 1985. He worked his way up to become a Journeyman Electrician and then eventually became a Master Electrician and Licensed Construction Supervisor. In 1999 Russ become an Electrical Instructor for The Peterson School of Engineering in Massachusetts where he developed his passion for teaching, and quickly became Department Head of Electrical Instruction. Russ has taught thousands of apprentices, electricians, engineers, inspectors, and other electrical professionals during his career as an instructor. He continues to provide electrical professionals with Electrical Code seminars, Arc-Flash Awareness training seminars and educational material through his LeBlanc Consulting Services in North Reading, MA whose specialty is educating electricians. He has been an active member of the NFPA Electrical Section and has authored hundreds of National Electrical Code proposals and comments which have become Code rules to improve the safety for the electrical industry. Russ is also an IAEI certified Electrical Inspector.

Please visit www.russleblanc.net for more information.

Voice your opinion!

To join the conversation, and become an exclusive member of EC&M, create an account today!

Sponsored Recommendations

Electrical Conduit Comparison Chart

CHAMPION FIBERGLASS electrical conduit is a lightweight, durable option that provides lasting savings when compared to other materials. Compare electrical conduit types including...

Fiberglass Electrical Conduit Chemical Resistance Chart

This information is provided solely as a guide since it is impossible to anticipate all individual site conditions. For specific applications which are not covered in this guide...

Considerations for Direct Burial Conduit

Installation type plays a key role in the type of conduit selected for electrical systems in industrial construction projects. Above ground, below ground, direct buried, encased...

How to Calculate Labor Costs

Most important to accurately estimating labor costs is knowing the approximate hours required for project completion. Learn how to calculate electrical labor cost.